Safe T Bond.™
|
|
Safe-T-Bond™ is formulated with strong initial suction / grab, which makes it ideal for installing wall panelling, flooring, skirting boards and architraves.
For installing particle board sub-floor to timber, steel and concrete joists. (Not for installing timber floors on top of particle board sub-floor or concrete slabs).
Solvent free Safe T Bond™ will not attack Polystyrene
It has no fumes and can be cleaned up with water.
Approvals
Bond strength exceeds requirements of AS2329 - 1999
|
|
SPECIFICATIONS
| Open Time |
20 min @ 25°C |
| Cure Time |
24 hours @ 25°C |
| Repositioning Time |
60 minutes @ 25°C |
| Service Temperature |
-5°C to 80°C |
| Application Temperature |
5°C to 35°C |
| Flammability |
Not Flammable |
Sag Resistance
(AS2329-1999, Appendix A) |
< 6mm |
Transfer
(AS 2329 - 1999, Appendix B) |
> 75% after 15 minutes open
time |
Aging
(AS2329-1999, Appendix C) |
No chipping or cracking after
500 hours at 70°C. |
Initial Bond Strength in Shear
(AS2329-1999, Appendix D) |
> 200 kPa |
Adhesion Strength in Tensile Shear
(AS2329-1999, Appendix E) |
> 1 MPa |
Bond Strength in Peel
(AS2329 - 1999, Appendix F) |
> 40N/25mm |
| Substrates |
Particleboard / Chipboard, Medium Density Fibreboard (MDF), Fibre Cement
Sheet, Softwoods , Hardboard, Plywood, Hardwoods with dry density <
1000 Kg / m3, Concrete, Expanded Polystyrene Foam, Galvanised steel |
| Flexibility |
Low |
Low VOC |
Yes |
| Water Resistance |
Low |
Paintable |
Yes |
| Water Immersion |
No |
Water Clean Up |
Yes |
| Heat Resistant |
No |
Exterior Use |
No |
| Fire Rated |
No |
UV Resistant |
No |
|
|
|
FEATURES & BENEFITS
- Low odour – no solvent fumes
- Easy clean up - use water
- Fast initial grab - minimises slippage on vertical surfaces.
- Easy to dispense at low temperatures.
- Bridges gaps up to 9 mm - effective on uneven surfaces
- Long repositioning time - up to 60 minutes
- Easy to use, re-sealable sausage – no caulking gun
- Will not attack polystyrene foam
|
|
|
INSTALLATION GUIDE
Refer to the Technical Data Sheets and MSDS for further detailed installation instructions and precautions.
- Ensure surfaces are clean and dry
- Cut sachet tip and place sachet in the dispensing tool ( SABGU37)
- Apply adhesive as a continuous bead onto studs or joists.
- Do not use to install timber floors over particle board sub-floor or concrete slabs
- Place floor or wall panel onto joists or studs and align
- Nail or screw as required
- Clean up Safe T Bond™ with a damp cloth before it dries
- Brace and support wall panels or light objects and remove when adhesive has set (approximately 24 hours)
|
|
|
TECHNICAL DATA & DOCUMENTS
PRODUCT INFORMATION
|
TECHNICAL INFORMATION
|
|
|
|
|
